steam turbine

1. The main fault mechanism and characteristics of steam turbine generator unit was researched.
   系统研究了汽轮发电机组的主要故障机理和特征。
2. Combined gas and steam turbine
   燃气机和汽轮机联合设备
3. A method for calculating the heat transfer coefficient of steam turbine casings is being presented.
   提出了汽轮机汽缸传热系数的计算方法。
4. The effect of the wetness on steam turbine efficiency and the etching effect on the blade were very complex.
   湿度对蒸汽轮机效率的影响及其对叶片的浸蚀作用极其复杂。
5. The cooling capability of Air cooling condenser has very great influence on vacuum of steam turbine.
   空冷系统的ACC凝汽器冷却能力大小，对汽机真空有很大的影响。
6. An example of evaluation of the steam turbine vane surface form error verifies the superiority of this evaluation method.
   以汽轮机叶片曲面形状误差评定为例，证实了该评定方法的优越性。
7. This approach can be an advanced and practical platform for analysis and design of wet steam flow in steam turbine.
   该方法可成为汽轮机湿蒸汽级流动的分析和设计的先进和实用的平台。
8. Experimental Study and Numerical Calculation of Blowing Performance for Hollow Static Blade of Steam Turbine
   汽轮机空心静叶吹扫性能的试验研究和数值计算
9. Steam turbine forced cooling safety analysis;
   汽轮机；强迫冷却；安全性分析；
10. The Numerical Analysis of Low Diameter seal and Opposite-teeth Labyrinth of LP Last Stage Diaphragm of Steam Turbine
    汽轮机低压末级隔板低直径汽封和对齿迷宫式汽封的数值分析对比
11. Hot-stability Analysis Method for Rotor Forging and Principal Spindle of Steam Turbine
    汽轮机主轴和转子锻件热稳定性分析方法研究
12. The reference flow is the most critical measure point in steam turbine performance testing.
    基准流量是汽轮机性能测试中最为关键的测点。
13. Optimal design and performance analysis of steam turbine exhaust system
    汽轮机排汽系统优化设计与性能分析
14. A steam turbine is coupled to an electric generator for the production of electric power.
    为了产生电力把蒸汽轮机连接到发电机上。
15. Study on Fault Diagnosis System for Rotor of Steam Turbine Generators
    汽轮发电机转子故障诊断系统的研究
16. Steam turbine Straight blade Thermal performance design Probabilistic design Reliability analysis;
    汽轮机；直叶片；热力设计；概率设计；可靠性分析；
17. Analysis of problems in application and start up of control system of steam turbine for feedwater pump
    给水泵汽轮机控制系统应用及启动中的问题分析
18. Steam turbine casing collision test is used to determine the minimum through-flow clearance between rotor and assembled casing parts.
    汽轮机缸体碰撞试验用来确定汽轮机转子与已装配好的汽缸零件之间存在的最小通流间隙。
19. Steam turbine governing system shaft torsional oscillation;
    汽轮机；调节系统；轴扭振；
20. In this paper, mechanics characteristic of LP cylinder and rotor is studied in large-power steam turbine.
    主要研究了大型汽轮机组低压汽缸与转子的力学特性。
21. One steam turbine is a condensing machine, the other a heating turbine and both drive one common generator through one single shaft line.
    一个汽轮机冷凝机，另一种加热涡轮机和两个驱动器通过单一轴线的共同发电机。
22. This paper discusses the feasibility to raise maximum speed of industrial steam turbine with titanium alloy LP twisted blading.
    论述了用钛合金低压扭叶片提高工业汽轮机极限转速的可行性。
23. Capacity and Parameter Optimizing of Cogeneration Steam Turbine
    对热电联产汽轮机容量和参数的优化意见
24. The structure of marine diesel exhaust gas turbo generator was introduced, and the working principle of the main components-exhaust gas boiler and steam turbine was analyzed.
    分析船用柴油机废气涡轮发电机系统中废气锅炉和汽轮机的工作原理；
25. To the problem of failure diagnosis of steam turbine generator set, principle and existing defects of genetic algorithm and BP network are analyzed.
    针对汽轮发电机组的振动故障诊断的特点，分析了BP网络和遗传算法原理和缺陷。
26. First analyse the steam turbine's vibration and its impact on the unit.
    首先分析了汽轮机组的振动概况及其对机组的影响；
27. The paper discusses some problems on small steam turbine generator unit for low vacuum heating.
    着重讨论了小型凝汽式汽轮发电机组低真空供热及运行的几个问题。
28. Techno-economic Analysis of Boiler Water Feeding Pump Driven by Steam Turbine in Thermal Power Plant
    热电厂汽轮机带动锅炉给水泵技术经济性分析
29. Two reactors, one big steam turbine hall and cooling towers for heat removal.
    2个反应堆，1个大蒸汽涡轮，还有除热量的冷却塔。
30. Numerical investigations about the influence of changing stator solidity on the steam turbine stage performance are presented.
    数值研究了蒸汽透平静叶节距变化对级性能影响。

noun

1. turbine in which steam strikes blades and makes them turn